|
There's a recall on cam bearings, 1999-2000 twin cams.
You or your dealer can phone the Factory with two engine serial numbers, the vehicle identification number, (VIN), that your bike is registered with off the left side engine casing at the base of the cylinders and the motor number off the bottom of the right engine case. If your engine was built before Dec. 14 1999 then you have the problem ball bearings. On and after Dec. 14 1999 and the new improved roller bearings with the new cam support plate will have been installed in your engine.Harley’s are built in ½ years not the full yearly production you are probably more familiar with.
The cam shoe you have in the pic is fine, however, I can't see the other one.
Call your dealer.....this may be covered.
__________________
HERD meber #10
DISCLAIMER: Any information, advice or child raising tips I give on this forum should be taken with a grain of salt, 8 hours sleep and at least 6 beers.
Following my instructions will likely lead to death, mental retardation and/or bodily injury, consistant with eating lead-based paint chips, and by doing so, will release me, my family and my dog from any legal action(s) for listening to anything I recommended. 
Last edited by Dave63 : 07-06-2009 at 04:20 PM.
|
