» Site Navigation |
|
» » » » Motorcycle Forums
|
|
» Links |
|
|
|
 |
|
10-11-2009, 11:45 AM
|
#1 (permalink)
|
|
Member
Join Date: Oct 2009
Location: Georgia
Posts: 92
|
60 Pan
Does anyone have a diagram for a single point distributor? Just got my pan started, but cant get above idle, when I try she spits and sputters backfires and dies. I am running a cv carb. Any help or suggestions would be greatly appreciated.
|
|
|
|
10-11-2009, 12:15 PM
|
#2 (permalink)
|
|
ready for FOWL play?
Join Date: Jul 2009
Location: USA
Posts: 3,867
|
welcome to the forum..........
__________________
HERD #00025
If there was no wrong, there could be no right
|
|
|
|
|
10-11-2009, 12:34 PM
|
#3 (permalink)
|
|
Member
Join Date: Oct 2009
Location: Georgia
Posts: 92
|
Thanks for the welcome
|
|
|
|
|
10-11-2009, 01:12 PM
|
#4 (permalink)
|
|
Mentally unstable.
Join Date: Jun 2008
Location: Pennsyltucky
Posts: 6,616
|
Quote:
Originally Posted by Phillip
Does anyone have a diagram for a single point distributor? Just got my pan started, but cant get above idle, when I try she spits and sputters backfires and dies. I am running a cv carb. Any help or suggestions would be greatly appreciated.
|
Can't get it above idle would indicate no fuel. Check for a blocked pilot jet, or vacuum leak, as the CV works off vacuum. There's a vacuum port on the top, rear, that's for the VOES sensor, that you don't have. It needs to be blocked off.
If it idles, the points should be ok, or close enough that it runs. Timing is something else........
__________________
HERD meber #10
DISCLAIMER: Any information, advice or child raising tips I give on this forum should be taken with a grain of salt, 8 hours sleep and at least 6 beers.
Following my instructions will likely lead to death, mental retardation and/or bodily injury, consistant with eating lead-based paint chips, and by doing so, will release me, my family and my dog from any legal action(s) for listening to anything I recommended. 
|
|
|
|
10-11-2009, 01:30 PM
|
#5 (permalink)
|
|
Member
Join Date: Oct 2009
Location: Georgia
Posts: 92
|
No problem with fuel. Timing seems to be ok. I was thinking maybe the weights are stuck in distributor. But I am new to panheads and dont want to screw up. Which I am naturally inclined to do. lol
|
|
|
|
|
10-11-2009, 01:32 PM
|
#6 (permalink)
|
|
Mentally unstable.
Join Date: Jun 2008
Location: Pennsyltucky
Posts: 6,616
|
Quote:
Originally Posted by Phillip
No problem with fuel. Timing seems to be ok. I was thinking maybe the weights are stuck in distributor. But I am new to panheads and dont want to screw up. Which I am naturally inclinded to do. lol
|
If the weights won't move, then it will still run and drive, it just won;t have the power it's supposed to over 1500-1800 rpms, due to lack of auto-timing advance.
Even if the weights were stuck in place, the bike't timing can still be advanced enough to run it down the road, which is why fuel is a suspect here.
__________________
HERD meber #10
DISCLAIMER: Any information, advice or child raising tips I give on this forum should be taken with a grain of salt, 8 hours sleep and at least 6 beers.
Following my instructions will likely lead to death, mental retardation and/or bodily injury, consistant with eating lead-based paint chips, and by doing so, will release me, my family and my dog from any legal action(s) for listening to anything I recommended.
|
|
|
|
|
10-11-2009, 01:37 PM
|
#7 (permalink)
|
|
Member
Join Date: Oct 2009
Location: Georgia
Posts: 92
|
I tried two carbs. the bike acted the same with both. We checked both carbs they seemed to be fine.
|
|
|
|
|
10-11-2009, 01:42 PM
|
#8 (permalink)
|
|
Member
Join Date: Oct 2009
Location: Georgia
Posts: 92
|
This is her
|
|
|
|
|
10-11-2009, 02:20 PM
|
#9 (permalink)
|
|
Mentally unstable.
Join Date: Jun 2008
Location: Pennsyltucky
Posts: 6,616
|
Try this....
__________________
HERD meber #10
DISCLAIMER: Any information, advice or child raising tips I give on this forum should be taken with a grain of salt, 8 hours sleep and at least 6 beers.
Following my instructions will likely lead to death, mental retardation and/or bodily injury, consistant with eating lead-based paint chips, and by doing so, will release me, my family and my dog from any legal action(s) for listening to anything I recommended.
|
|
|
|
|
10-11-2009, 02:21 PM
|
#10 (permalink)
|
|
Member
Join Date: Oct 2009
Location: Georgia
Posts: 92
|
Other pics
Here are a couple of other pics.
|
|
|
|
|
|
| Thread Tools |
|
|
| Display Modes |
 Linear Mode
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
|
