Quote:
Originally Posted by Dunnburger
Hey, lookin for some help. Have a ground up custom build with a 6 speed Ultima Trans. What speed sensor do I need to run with that for an electronic speedo. Any help is appreciated.
|
Check with Ultima. If you're putting it in an HD case, then use the appropriate year HD speed sensor, located in the right rear of the case, near the end of the starter.
Not sure if an HD sensor is a direct fit for the Ultima case, if that's the case (no pun) and the trans case is where it's going into. If the HD fits, then you need to match the sensor to the speedo, (HD?)regarding brand, due to length/diameter to not only fit the case, but not hit the exciter ring and making sure it sends the correct signal to the speedo.
HD speed sensors not only run the electronic speedo and odometer, but also send a signal in 4 speed bands to the turnsignal control module to cancel the turnsignals.
Speedo kit instructions, including sensor:
http://www.ultimaproducts.com/98-901SixSpdKit.pdf
__________________
HERD meber #10
DISCLAIMER: Any information, advice or child raising tips I give on this forum should be taken with a grain of salt, 8 hours sleep and at least 6 beers.
Following my instructions will likely lead to death, mental retardation and/or bodily injury, consistant with eating lead-based paint chips, and by doing so, will release me, my family and my dog from any legal action(s) for listening to anything I recommended.
Linear Mode
