Handlebar Wiring Issue

[Irish Ninja]

Just added 4 1/2" pullback risers to my 2010 SGC, issue---my right wiring sleeve is very tight with my handlebars turned at the far left, how do I get in and puul/extend the wiring out about an inch??? Any help is much appreciated before I end up snapping the wiring.

[RubberDown]

Underneath the back bone, over the front cylinder. You may have a plastic cover. If you push in on the tabs on the sides, this cover will drop down. You can then stretch out the wiring and pull it through the side fame opening more easily. I noticed on my bob I had several inches of extra wiring stuffed in there.

[Irish Ninja]

Thanks, I wish I had a couple of extra inches stuffed somewhere, at least that's what the wife says, ha ha. Thanks Dude, I appreciate the help

[RubberDown]

I learned a long time ago - It's all about YOU.... SHE may want it, but as long as you get yours.....


It may be easier to get to the cover's tabs on the side to push in the tabs with the tank loose and lifted up a couple of inches.