Assessory circuit connector? - Harley Davidson Forums: Harley Davidson Motorcycle Forum

Leigh · 08-15-2009, 06:08 PM

I am trying to locate the assessory circuit connector on an 2008 Ultra classic. Can someone please help me.
Thanks,
Leigh

P.S. A picture would be great. The instructions from H-D aren't helping me. I have installed a Tour pak spoiler.

Leigh · 08-15-2009, 06:27 PM

Found in-front of battery.

**Dave63** · 08-15-2009, 06:30 PM

under the seat? Gray connector?

streetnoyz · 08-15-2009, 06:31 PM

yes pull the seat then look in front of the battery. i believe it will be a 4 pin connector that is plugged by a dummy connector. I believe the accy hot wire is orange w/white stripe. always use a voltmeeter or equivelent test equiptment to be sure.

Leigh · 08-15-2009, 08:34 PM

Guys,
I found the plug connector with the four pins inside, but when I pluged the connection in from the tour pac spoiler, it did not work. Than I attached the plug pins from the spoiler, and that did not work as well. I an going in the morning to the Oak Beach to see if anyone there can assist me as well. I am very fustrated about this hook up. If i had to do it again, I think i WOULD HAVE THE DEALER INSTALL.

The good thing is I installed the spoiler on the tour pack straight. But that took 2 hours!

So, I am taking a brake now, 8:30pm. Started this project at 3pm. I did clean the bike while I had everything appart., bags off, seat off, side covers off. I am toast!

SCHMIDTYS · 08-16-2009, 09:09 AM

Shouldn't have had to go all the way to the access. plug . The spoiler should have had a Y connector that plugs into the tour pack harness right inside the bottom of the tour pack .

SCHMIDTYS · 08-16-2009, 09:47 AM

Correction . You said " spoiler " and I was thinking led tour-pack rack . The Y connector that comes with the led tour-pak rack would work with the spoiler too . You will also have to install pins and connector on the spoiler wires to be able to plug into the Y adapter .

Leigh · 08-16-2009, 12:11 PM

Ok, went to Oak Beach and saw some friends there. I am an a**. I was installing the pins in backwards. I inserted them in correctly now, and the dam thing works! It is easy once you know what your doing, took me 2 minutes. The H-D instructions are not that good. Thank you all for your assistance.

Leigh...