Need help 2000 Dyna Turn Signal timing

[Retszat]

I know there is probably an easy reset but right now my right turnsignal turns off almost immediatly after i turn it on. How do i reset the timing back to factory. also how do i avoid the signal timing changing in the future?

[XDixiecratX]

You will get a better responce if you say Hello in the new to the community page

[Retszat]

Thaanks I will

[Glyde]

I found these charts in my manual.

Distance test
0-34 mph - 221 ft
35-44 mph - 339 ft
45-60 mph - 680 ft
61+ mph - 1051 ft

Time test
25mph - 5-7 second
38mph - 5-7 sec
52mph - 8-10sec
65mph - 10-12sec

I dont see where this can be reset, but I do see instructions on how to change the "turn signal module". Try a test or two to see. There is also a "rider preference" note that says the count down starts when the button is released, so ya can hold it in, to make the flash last longer.

BTW, I ride a 2000 FXD and the info should be right for your sled. Check your dealer or Ebay, I aint much of a wrench, but the HD manual can help and save ya some $$$$.

[SCHMIDTYS]

You can't change a thing in a " turn signal module " . No adjustments . Make sure all the bulbs are good and the turn switch isn't broken or sticking . No pinched wires in the switch housing . No bad grounds . If you eliminate the obvious things then put in a new TSM .