Harley Davidson Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter #1
Can anyone tell me if a 12" replacement from the factory 10" mini ape will require changing my clutch and throttle cables?

2013 Harley seventy two sportster 1200.
 

·
Fla Cajun
Joined
·
25,353 Posts
I'm no expert, but i'd think you should be able to do 2''.....my cables were long enough to add 4'' risors before i went with apes. Your brake cable may be a little tight, mine was.
 

·
Retired citizen
Joined
·
23,470 Posts
The biggest problem when changing bar height and length is the front brake line. The other cables and wires will usually accommodate a couple extra inches.
 

·
Registered
Joined
·
529 Posts
Can anyone tell me if a 12" replacement from the factory 10" mini ape will require changing my clutch and throttle cables?

2013 Harley seventy two sportster 1200.
I went from a straight drag bar to a 4" rise zbar on my 07 xl1200c without changing cables. I relocated turn signals to the fork. If I wouldn't have done the light relocate, I would have had to extend the wiring if I ran wire through the bars though.
 
1 - 6 of 6 Posts
Top