Harley Davidson Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
So this is a messed up issue that has a lot of people stumped so here goes.

My turn signals do not work when I press the buttons. Every other time I turn the ignition on the 4 ways come on and stay flashing and will flash until I cycle the ignition.

The security light is not lit and I dont have a fob.

I replaced the factory turn signals and fog lights with flush mount lights on the crash bar.

The battery shorted out at some point over the winter and I dont think it hurt anything however the battery was completely shot and I replaced it with a new one but never jumped the bike or put a jump pack on it.

Any help is appreciated.
 

·
Retired citizen
Joined
·
22,313 Posts
Hey OP the first thing I would do is verify the battery volts. A fully charged battery will measure approx. 12.8 volts across the terminals at static. Every 10th of a volt counts. Like 12.5v is a 50% discharged battery.
The next thing I would do is check for codes, the procedure is a sticky in the electrical section under DTCs.
 
1 - 4 of 4 Posts
Top