Harley Davidson Forums banner

1 - 5 of 5 Posts

·
Stranded.....in Iowa
Joined
·
493 Posts
Discussion Starter #1 (Edited)
Looking at the chrome electrical panel cover on the HD site, it says fits a 2010 Wide Glide - I dont' see the 2 screws as on the stock cover. They are located toward te back of the bike. the intruction sheet says grab it and pull it off - I seriously think mine is screwed on. Am I missing soemthing here? Not my bike in the pic, circled the 2 screws on the cover I was talking about.
 

Attachments

·
Registered
Joined
·
2,534 Posts
held on by rubber grommet thingys - just give it a good tug
 

·
Stranded.....in Iowa
Joined
·
493 Posts
Discussion Starter #4
This place is great, that's just what I was looking for. Those 2 screws or whatever must be decorative. Thanks.
 

·
Registered
Joined
·
3,659 Posts
I have a 2012 WG and my cover does not have any screws. Nothing is attached to the cover on the inside either. To remove the cover, you have to press a release tab below it on the bottom right while pulling up and out on the metal cover. Hope this helps.
 
1 - 5 of 5 Posts
Top