Harley Davidson Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
11 Posts
Discussion Starter #1
The plastic fuel inlet fitting on my 1990 FLHTCU carb has cracked right where it goes into the carb. I removed the plastic piece and have ordered a new brass fitting but need to know if anyone has a easy solution for removing the old brass end of the fitting that is still in the side of the carb and then installing the new one? Any help would be greatly apprecieated.
Bull
:biking:
 

·
Retired citizen
Joined
·
22,051 Posts
There's a thread somewhere here by Dave63 with the procedure to get the rest of the fitting out of the carb, pictures and all !
Try some searches or look for stickys in the fuel section.
I just looked, it's a sticky in the fuel section, 3rd from the bottom of the page.
 
1 - 4 of 4 Posts
Top