Harley Davidson Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
57 Posts
Discussion Starter #1
I'm putting on a set of Rush slip-ons but there's no instruction sheet. Anyone know the torque specs for the exhaust clamps? I checked the stickys and couldn't find the info. Also, I know HD doesn't recommend re-using the clamps, but the bike has 850 miles on it. Do you think they will be OK?
Thanks
 

·
Registered
Joined
·
57 Posts
Discussion Starter #2
Disregard. Found them..45-60 ft lbs.
 

·
Señor Member
Joined
·
19,598 Posts
Which clamps? Muffler to headpipe?

I reuse all exhaust hardware once at least unless it looks worn or damaged. I replaced head O ring gaskets just because I had them.
 

·
VA Fender Bender
Joined
·
5,549 Posts
I called Rush and they recommended new clamps and 65-70 ft lbs torque. They said their pipes were thicker and required a heavier torque spec.
 
1 - 6 of 6 Posts
Top