Harley Davidson Forums banner

1 - 1 of 1 Posts

·
Registered
Joined
·
39 Posts
Discussion Starter #1
Havet been in here for a while. After waiting a few months almost 3 got my 2 into 1 Hacker pipes for my 86 FXRS-SP (Low Rider) SE.
The bracket sent to be installed on the trany wont work because of a 1" tall boss on the cover that has a bracket to the end of the starter.
They set another bracket that is susposed to bolt to the slider on the can and stock rubber mount. Its too long by about 2 inches. Bigger issue is neither bracket will not fit between the frame and the pipe.
If I INSTALL A WALKER 2.5 ID TO 2.5 OD connector between the can and collector it lines up with the stock mount.
Anyone run into this
 

Attachments

1 - 1 of 1 Posts
Top