Harley Davidson Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
179 Posts
Discussion Starter #1
My 99wg. has what appears to be the stock apes with the wiring for controls running thru those "fugly" little plastic routs. If i stay with this size ape's,how hard is it to rout all wiring internally? Are the new bars the same size diameter or are they beefier?...thx's


Sent from Motorcycle.com Free App
 

·
Wayward Son
Joined
·
23,313 Posts
Inner diameter is going to depend on the make and model of bars you get.
Some are larger in diameter by design mostly for cosmetic reasons. Does make it a bit easier to run the harnesses.
 

·
I {Heart} Hookers.
Joined
·
31,321 Posts
OEM is 1". It can be done but more effort than if inside 1.25" bars.
 

·
Registered
Joined
·
179 Posts
Discussion Starter #4
Thx's. Will i need to change out my stock risers to accomodate a 1.25" set of bars,and also can the wiring for the controls be disconected at the controls and fed thru from the bottom of the new bars??
Thx's again!


Sent from Motorcycle.com Free App
 

·
Banned
Joined
·
71 Posts
Thx's. Will i need to change out my stock risers to accomodate a 1.25" set of bars,and also can the wiring for the controls be disconected at the controls and fed thru from the bottom of the new bars??
Thx's again!


Sent from Motorcycle.com Free App
Easier to pull the plugs and feed wires from the top down, put plugs back on . :thumbsup


:coffee:
 
1 - 6 of 6 Posts
Top