Harley Davidson Forums banner
1 - 4 of 4 Posts

· Registered
Joined
·
34 Posts
Discussion Starter · #1 ·
I built a new front end on 2006 Dyna Wide glide after trading for pick-up truck. Changed super high apes to T-bars and went to put on oem chrome lower legs. Found tubes were slightly tweaked. Went with 4" over tubes, new seals and progressive springs and big 21 front tire. Front end definitely rides better. Only thing now is when I stop and put oem jiffy stand down bike almost tips over. I am asking what solution(s) there is from forum to get bike to set like stock. I see one inch over jiffy stands but they don't fix problem according to purchasers. I am going to use torch to adjust the two bends to compensate for radical angle of stock stand. But will consider any other advice. Ride safe...
Wheel Tire Land vehicle Fuel tank Vehicle
 

· Registered
Joined
·
2,214 Posts
I can't help with the stand issue, but welcome from Virginia and great looking bike
 

· Registered
Joined
·
268 Posts
Bike looks good
Easiest option is lift blocks, best option is proper length stand if you have an indy shop around.

Just an example of lift blocks

Their website, 2in is max
 
1 - 4 of 4 Posts
Top