Harley Davidson Forums banner

1 - 8 of 8 Posts

·
Registered
Joined
·
73 Posts
Discussion Starter #1
Doing SE hydraulic cam plate, oil pump upgrade. Purchased new S&S tappets, quickie pushrod kit and cam plate upgrade. Which Andrews cam part number do I need to get for my 01 FLHRI? They have different letter codes on them and to be honest it's confusing and I don't want to order wrong ones.
 

·
Banned
Joined
·
71 Posts

·
Registered
Joined
·
73 Posts
Discussion Starter #7
Haven't bought cans yet. What would be a better choice? Going to go to a 97" kit also. Thanks for the help.
 

·
Registered
Joined
·
1,940 Posts
With that bore size under the advertised 85cc chamber, and a .030" head gasket, you'll be at/very near that compression ratio.
We've built many of those using our 98" piston/gasket kits, and boring the OEM cylinder.
Good rip up off the bottom and mid, even without headwork, but headwork will allow it to carry out further, creating a broader torque curve.:)
Scott
 
1 - 8 of 8 Posts
Top