Harley Davidson Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter #1
I've got an 08 FLHTC that I'm going to attempt to install the security system on myself. The instructions that came with it tell me to refer to my service manual, but there really isn't any detailed information there either! Can anyone help me out here?
 

·
Registered
Joined
·
39,569 Posts
Both the first gen systems (with the button on the fob) and the 2nd gen systems (hands free operation) install the same way. The TSSM (Turn Signal Security Module) replaces the TSM (Turn Signal Module).

Heres some pictures of an install of the first gen type system on a
http://www.hotbikeweb.com/tech/0408hb_harley_davidson_alarm/index.html

Once you have the parts installed and wires plugged in, you have to marry the TSSM to your bike.

Tssm Marriage
1 Set Run switch to Run

2 Turn Ignition key On-Off-On-Off-On-Off-On and then toggle
the Left Turn Signal switch twice.

3 Turn Ignition key Off-On Verify the Check Engine lamp and Security Lamp illuminate
briefly and then turn off Security lamp will not illuminate on non-security
(TSM) Twin Cam models.

4 Attempt normal start one time. Engine starts and stalls immediately. check engine
lamp stays on. Password has not been learned and sets trouble code P1009, thus stopping fuel
flow.

5 Wait 10 seconds Security Lamp remains lit for V-Rod and TC88 with TSSM. Lamp will not be on for TC88 TSM models. ECM enters Password Learning mode for 10 minutes.
Do Not cycle the ignition or disrupt power.

6 Wait until Security Lamp turns off or a minimum of 10 minutes has passed.

7 Quickly (within 2 seconds) turn Ignition key OFF-ON Security Lamp remains lit for V-Rod and TC88 with TSSM. Lamp will not be on for TC88 TSM models.

8 Wait until Security Lamp turns off or a minimum of 10 minutes has passed. Password Learning mode for 10 minutes. Do Not cycle the
ignition or disrupt power.

9 Quickly (within 2 seconds) turn Ignition key OFF-ON Security Lamp remains lit for V-Rod and TC88 with TSSM. Lamp will not be on for TC88 TSM models.

10 Wait until Security Lamp turns off or a minimum of 10 minutes has passed. Password Learning mode for 10 minutes. Do Not cycle the ignition or disrupt power.

11 Quickly (within 2 seconds) turn Ignition key OFF-ON Security Lamp light and then turn off. Lamp will not be on for TC88 TSM models.

12 Turn Ignition switch OFF. Wait 15 seconds. Turn Ignition switch ON and start engine to confirm the Password Learn Procedure is successful. Engine will start and remain running
If engine immediately stalls and fails to restart the Password Learning mode was not successful. Start over at step 1.


Then, once you get this far, you will have to take your bike and fob to the dealer to get programmed to work together. :bash:
 
1 - 3 of 3 Posts
Top