Harley Davidson Forums banner
1 - 1 of 1 Posts

·
Banned
Joined
·
0 Posts
Hey fellas, got a 1998 Dyna Low Rider, I recently changed the rear blinkers and rear brake light with J&P Cycles tombstone one piece light... I only had to wire 7 wires, 2 for each blinker & 3 for main break light... I made sure I wired them correctly and now when I use the blinkers, they stay solid, they don't blink... Any ideas??
J&P Cycles® Tombstone Taillight and Turn Signal Combo with LEDs | 306-635 | J&P Cycles
Did you perchance use the LED unit ? If so, it will not draw enough current to flash the turn signals without adding a set of resisters in the circuit .

J&P Cycles® Tombstone Taillight and Turn Signal Combo | 3400591 | J&P Cycles
If you used their other unit , make sure that the duel black and duel red wires are not reversed .
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top