Harley Davidson Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
83 Posts
Discussion Starter · #1 ·
Hey fellas, got a 1998 Dyna Low Rider, I recently changed the rear blinkers and rear brake light with J&P Cycles tombstone one piece light... I only had to wire 7 wires, 2 for each blinker & 3 for main break light... I made sure I wired them correctly and now when I use the blinkers, they stay solid, they don't blink... Any ideas??
 

·
Registered
Joined
·
83 Posts
Discussion Starter · #8 ·
Thanks guys, they are the LED's... Didn't know about resistors, have to look into that... The wiring is correct, they were pretty much all the same color that had to be reconnected, except for 1, but tried 2 ways with that wire...
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top