Harley Davidson Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
On my '05 Sportster there is a rubber conduit for the tail light/ turn signal wiring harness. From what I can see, that conduit was glued up under the fender. Now it's come loose and is flopping on the rear tire. What kind of glue should I use to put that back on, or is there something better to do to hold that cable in place? Some kind of clip?
Thanks
 

·
Banned
Joined
·
71 Posts
On my '05 Sportster there is a rubber conduit for the tail light/ turn signal wiring harness. From what I can see, that conduit was glued up under the fender. Now it's come loose and is flopping on the rear tire. What kind of glue should I use to put that back on, or is there something better to do to hold that cable in place? Some kind of clip?
Thanks
You can use the fender clips and weatherstrip adhesive both. 3-M makes the better type .


:coffee:
 

·
Registered
Joined
·
2 Posts
Discussion Starter #4
tail light harness

Thanks for the comments. Just took the fender off and didn't see any clips or places where they might have been. The rubber conduit was covered in glue, but no sign of glue on the fender so it didn't adhere very well.
I'll be picking up some fender clips and adhesive.
Thanks again.
 
1 - 4 of 4 Posts
Top