Harley Davidson Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter #1
Gonna change my front fender trim HD 59002-98 on my 07 heritage it says to remove the deutsch electrical connector. I was just gonne snip the connector and tape it not slip out the wire in case there might be a time I might want to put the original back on at a later time. Buddy says slip out the wire I think leave it where it is and tape it up any opinions?
 

·
Registered
Joined
·
87 Posts
Don't bodge the harness. Slide the pin out and put a piece of heat shrink on it. If you cut it you'll have to splice it to reuse it, which inevitably leads to future problems.
 

·
Old Member
Joined
·
2,896 Posts
The wires in the Deutsch connector are locked into place by little locking tabs. Use a tiny flat tip screwdriver to unlock the wires to be removed by gently sliding it between the wire and locking tab. It is easiest to unlock and pull out one wire at a time.
 
1 - 3 of 3 Posts
Top